Section 3 Web Programming - NEC SL2100 Getting Started Manual

Section 3 Web Programming

This section shows how to connect to the SL2100 Web programming and configuration
changes.
The PC must support the following browsers for the Web programming:
System
CPU
Memory
OS
Browser
Monitor Resolution
Communication Port
By default, the SL2100 is enabled to receive its IP address, Subnet Mask and Default Gateway
from the network's DHCP server.
1. Connect the PC to the Ethernet port on the CPU-C1 using a LAN cable.
LAN Cable
2. Connect the Web Programming.
Launch any supported browser and enter the IP addresss of the SL2100 system. If a DHCP
server does not exist, refer to the following chart:
SL2100 IP Address
192.168.0.10
3. When the WebPro Login Screen is displayed, enter the User Name and Password (using
PRG90-02).
CPU and Memory are dependent on the Microsoft Operating System Memory
environment used.
Windows 7, Windows 8.1, Windows10
Internet Explorer 11 or later
Firefox 42 or later
Chrome 52 or later
Microsoft Edge TBD
1024×768 pixel over
LAN, Modem or ISDN
CPU-C1 board
PC
SL2100 Subnet Mask
255.255.255.0
SL2100 GETTING STARTED GUIDE
Minimum Requirements
Your PC Address
192.168.0.11
Your PC Subnet Mask
255.255.255.0
69