Section 2 Entering The Telephone Programming Mode (Tel Pro); How To Enter Programming Mode; Selecting The Programming Number; Exiting The Programming Mode - NEC SL2100 Getting Started Manual

SL2100 GETTING STARTED GUIDE

Section 2 Entering the Telephone Programming Mode (Tel Pro)

The installer/system administrator can enter system programming mode from a display
type key telephone. (Up to two users can enter to the mode at the same time)
--Program Mode
System data is identified by a number.
Enter the number using the keypad to select the Program Number.
⇒In a newly installed system, use extension port No.1.

2.1 How to Enter Programming Mode

The installer/system administrator can enter system programming mode using a display type multiline
telephone. (A maximum of two users can enter mode at the same time.)
1) Press Speaker. (Do not lift the handset)
2) Dial # * # *.
____1-17_TUE__ 1:07PM____
101______________DONALD
_Menu__Dir__VM:00_CL:00_
3) Dial the system password, then press Hold key to enter Program Mode.
Passward
@@@@@@@@___________
For the programming details, refer to the SL2100 Programming Manual.

2.2 Selecting the Programming Number

Each configuration setting within the SL2100 is identified by a Program Number (e.g., 10-01-01).
1) Ensure the LCD display shows.;
If it is not displayed, press the Mute key several times to returns the previous screen.
_________________________
______Program
_Base_Service_OP1__OP2__
2) Enter the Program Number (e.g. 10-01-01).
10-01-01_________________
Year__________17________
___←_______________→___
If you dial an incorrect Program Number, you can returns the previous screen by pressing the Mute key.
If you enter incorrect data, you can returns the previous screen without saving the setting by pressing the Mute
key.

2.3 Exiting the Programming Mode

Press Mute key several times to return to the "Program Mode" Screen.
1)
10-01- ________Sys Config
Time&Date Setup
back
↑
2) Press Speaker key to exit.
_________________________
______Program
_Base_Service_OP1__OP2__
The system automatically saves the customer data to memory, which is backed up using a lithium battery.
50
Mode_______
|01
select
↓
Mode_______
Passward_________________
_________________________
______Program Mode_______
_Base_Service_OP1__OP2__
_________________________
______Program Mode_______
_Base_Service_OP1__OP2__
____1-17_TUE__ 1:08PM____
101______________DONALD
_Menu__Dir__VM:00_CL:00_