Datalogic RIDA DBT6400 Product Reference Manual page 258

References
Set Length 2
This feature specifies one of the bar code lengths for a given symbology.
Length 2 is the maximum label length if in Variable Length Mode, or the second
fixed length if in Fixed Length Mode.
Reference the
(number of characters) for the symbology being set. A setting of 00 specifies to
ignore this length (only one fixed length).
Follow these instructions to set this feature:
1. Determine the desired character length. Pad the number with leading
2. Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Program-
3. Scan the "Select Length 2 Setting" for the symbology being set.
4. Scan the appropriate two digits from the keypad in
NOTE
5. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming
This completes the procedure. See the table below for examples of how to set
this feature.
Table 18. Length 2 Setting Examples
STEP ACTION
1 Desired Setting
2 Scan ENTER/EXIT PROGRAMMING MODE
3 Scan SELECT LENGTH 2 SETTING
Scan Two Characters From
4
Appendix D, Keypad
5 Scan ENTER/EXIT PROGRAMMING MODE
250
1D Symbologies on page 105
zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
ming Mode.
represent the length setting which was determined in the steps above. You
will hear a two-beep indication after the last character.
If you make a mistake before the last character, scan the CANCEL bar
code to abort and not save the entry string. You can then start again
at the beginning.
Mode.
EXAMPLES
00 (ignore second
length)
'0' and '0'
section to view the selectable range
07 Characters 52 Characters
'0' and '7' '5' and '2'
Appendix D, Keypad, that
74 Characters
'7' and '4'
RIDA™ DBT6400