Advertisement
Part names and functions
3D Eyewear can be worn over vision correction glasses.
Pull
Indicator lamp status
Indicator lamp
Lights red for 2 seconds when turned on
Flashes 5 times when turned on
Flashes red and green alternately
Flashes green once every 2 seconds
Lights green for 3 seconds
Flashes red 3 times
Flashes red once every 2 seconds when in use
Flashes red twice every 4 seconds when in use
Storing and cleaning the 3D Eyewear
Use the supplied 3D Eyewear case to store the 3D Eyewear.
Avoid storing the 3D Eyewear in hot or highly humid locations.
Use a clean, soft and dry cloth to wipe the 3D Eyewear. Otherwise, dirt or dust may scratch the eyewear.
Do not use benzene, thinner, or wax on the 3D Eyewear, as doing so may cause the paint to peel off.
Do not submerge the 3D Eyewear in liquid such as water when cleaning.
As the liquid crystal shutters (lens) are fragile and easily broken, be very careful when cleaning them.
Power switch
Slide the tab to the "ON" / "OFF" position to switch the power on/off.
Each time slide the tab to the "MODE" position to change the mode
between 3D and 2D (view a 3D image in 2D).
Registration
(p. 32)
Indicator lamp
Lights or flashes during use to show the status.
Insulating sheet
Battery cover
When using for the first time, remove the insulating sheet. Pull the
insulating sheet.
To replace the battery
"Replacing the battery" (p. 33)
Sufficient battery level
Low battery level
Under pairing
Under reconnecting to the TV
Pairing or reconnecting is successfully completed.
Automatically power off (Pairing or connecting fails or
connection is lost)
3D mode is selected
2D mode is selected
Status
31
Advertisement
