Table of Contents
Advertisement
Installation & Setup Guide
10. Goto
Goto
• Goto will place that cue on stage in the time setup in Show Options>Cue List. Press [GOTO] [#] [ENTER] to take
the selected Cue List to the desired cue.
• When using the [NEXT] key, a desired time for the cue to execute can be set. The recorded time is the default time.
11. Group
Group
• A Group is a defined selection of channels at a recorded level. Activate a selection of channels at a level, then type
[REC] [GROUP] [1] [ENTER]. With the channels released, activate the group by typing [GROUP] [1] [FULL] to
apply the selected channels at their recorded levels. To only select the channels, type [GROUP] [1] [ENTER]. The
levels can now be adjusted with the level wheel or any level adjusting key. i.e. Full, On, Up%, Down%.
• Technically, these are stored as Looks, but you can just record and call up groups as previous generations of desks
have done.
• See "Show Options" in the PaletteOS software Help Menu for assigning Look pages to this key.
12. Halt / Back
Halt / Back
• The [HALT/BACK] button will halt any running cues on its Cue List. A cue is running when the Green LED on
the GO button is flashing.
• If a Cue List is halted (flashing Red LED), pressing this button again will back up the Cue List.
• If the Cue List is releasing, both the [GO] and the [HALT/BACK] LEDs will be flashing.
• [SHIFT] [BACK] will go to the previous cue in recorded time. (This is very useful for encores.)
3 0
Controls
Light Palette Lighting Control Console
Advertisement
Table of Contents
