Chapter 2
power dc input
To configure the power DC input parameters on the switch, use the power dc input command. To return
to the default power settings, use the no form of this command.
Syntax Description
watts
Command Default
DC power input is 2500 W.
Command Modes
Global configuration mode
Command History
Release
12.1(11)EW
12.1(13)EW
Usage Guidelines
If your interface is not capable of supporting Power over Ethernet, you will receive this message:
Power over Ethernet not supported on interface Admin
Examples
The following example shows how to set the total capacity of the external DC power source to 5000 W:
Switch(config)# power dc input 5000
Switch(config)#
Related Commands
Command
show power
power dc input watts
no power dc input
Sets the total capacity of the external DC source in watts; valid values are from
300 to 8500.
Modification
This command was introduced on the Catalyst 4500 series switch.
Support for dc input was added.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
Description
Displays information about the power status.
power dc input
2-567