Using The Auto-Adjustment Function (Rgb Input Source Only) - HP LD4201 User Manual

Using the auto-adjustment function (RGB INPUT source
only)
You can optimize the screen performance by using the
button on the remote control) and the Auto-adjustment Pattern Utility software on the CD provided.
NOTE: Do not use this procedure if the display is set to use a DisplayPort or HDMI/DVI input
source.
If the monitor is using a PC analog signal input, this procedure can correct the following image quality
conditions:
Fuzzy or unclear focus
Ghosting, streaking or shadowing effects
Faint vertical bars
Thin, horizontal scrolling lines
An off-center picture
To use the auto-adjustment feature:
1. Allow the display to warm up for 20 minutes before adjusting.
2. Press the
If the result is not satisfactory, continue with the procedure.
3. Insert the CD in the disc drive. The CD menu appears.
4. Select Open auto-adjustment software. The setup test pattern appears.
5. Press the
6. Press the
ENWW
2nd Draft
AUTO/SET button.
AUTO/SET button to produce a stable, centered image.
ESC key or any other key on the keyboard to exit the test pattern.

Using the auto-adjustment function (RGB INPUT source only)

AUTO/SET button on the display (AUTO
29