Button Lockouts; Using The Auto-Adjustment Function (Analog Input) - HP P24h User Manual

Button lockouts

The button lockout function is available only when the monitor is on, an active signal is displayed, and the OSD
menu is closed. Holding down the power button or
re-enable the button by holding it down again for 10 seconds.

Using the auto-adjustment function (analog input)

The auto-adjustment feature automatically engages and attempts to optimize your screen under several
conditions.
Monitor setup
●
Factory reset of the computer
●
Changing monitor resolution
●
You can manually optimize the screen performance for the VGA (analog) input at any time from the
Auto Adjustment menu in the OSD. You can download the auto-adjustment pattern software utility from
http://www.hp.com/support.
Do not use this procedure if the monitor is using an input other than VGA. If the monitor is using a VGA
(analog) input, this procedure can correct the following image quality conditions:
Fuzzy or unclear focus
●
Ghosting, streaking, or shadowing effects
●
Faint vertical bars
●
Thin, horizontal scrolling lines
●
An off-center picture
●
To use the auto-adjustment feature:
1. Turn the monitor on, and then wait for 20 minutes before adjusting.
2. Press the
result is not satisfactory, continue with the procedure.
Menu button to open the OSD menu, select Image, and then select Auto Adjustment. If the
Menu button for 10 seconds disables that button. You can
Button lockouts 19