Power Requirements - GE akta pure Operating Instructions Manual

4 Installation
4.1 Site preparation

4.1.4 Power requirements

4.1.4 Power requirements
Introduction
This section describes the power supply requirements for ÄKTA pure.
Electrical power requirements
The table below specifies the electrical power requirements.
Parameter
Supply voltage
Frequency
Transient overvoltages
Typical power consump-
tion
Max power consump-
tion
Number of sockets
Type of sockets
Location of sockets
64
Requirement
100 to 240 V AC ±10%
50/60 Hz
Overvoltage category II
300 VA in state Run
165 VA in state Ready
25 VA in state Power-save
1100 VA
1 socket per instrument, up to 3 sockets for computer
equipment
EU or US plugs. Grounded mains sockets, fused or protect-
ed by equivalent circuit breaker.
Maximum 2 m from the instrument (due to length of mains
cable). Extension cables can be used if required.
WARNING
Protective ground. The product must always be connected to a
grounded power outlet.
ÄKTA pure Operating Instructions 29022997 AF