WARNING! NEVER apply voltage or current to the multimeter that exceeds the specified maximum as shown below:
Input Limits
Function
V AC
V DC
mA DC/AC
A DC or A AC
(30 seconds max every 15 minutes)
Resistance, Diode,
Temp, Continuity
1.4.
BATTERY INSTALLATION
WARNING! To avoid electric shock, disconnect the test leads
from any source of voltage before removing the battery cover.
Disconnect the test leads from the meter.
Open the battery cover by loosening the two screws using a
Phillips head screwdriver. Remove old battery (if applicable)
and insert the new battery into battery holder, observing the
correct polarity. Fit the battery cover back in place. Secure it
with the screws.
WARNING! To avoid electric shock, do not operate the meter
until the battery cover is in place and fastened securely.
NOTE! If your meter does not work properly, check the fuses
and battery to make sure that they are still good and that they
are properly inserted.
2. FEATURES
High precision auto-ranging multimeter. Conforms with EN61010-1
CATIII 600V safety requirements for electrical equipment for
measurement, control, and laboratory use. Features temperature
measurement capability, max/data hold and auto power off
function. Double moulded housing with soft grip case and large.
Practical probe and lead storage and integral upright stand for use
on the workbench.
Measures:
• AC and DC Voltage
• AC and DC Current
• Resistance
• Diode Test
• Continuity Buzzer
• Temperature
1.
LCD Display
2.
Function Switch
3.
10A Jack
4.
COM Jack
5.
Positive Jack
6.
Mode Switch
7.
Range Switch
8.
Data Hold Switch
9.
MAX. Hold Switch
© Jack Sealey Limited
Maximum Input
600V AC
600V DC
200mA
10A DC/AC
500V DC/AC
SYMBOLS AND ANNUNCIATORS
•)))
Continuity Test
Diode Test
µ
Micro (Amps)
m
Milli (Volts, Amps)
k
Kilo (Ohms)
Ω
Ohms
VDC
Volts Direct Current
VAC
Volts Alternating Current
ADC
Amps Direct Current
BAT
Battery Test
Original Language Version
REMOVE SCREWS
TO ACCESS
BATTERY AND
FUSES
1
7
6
2
3
5
4
TM102
Issue No: 2(I)- 19/06/14
8
9