Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Smoke hollow 105
Summary of Contents for Smoke hollow 105
- Page 1 Owner’s Manual Tabletop Gas Grill Model # 105 THIS IS YOUR ASSEMBLY, CARE & USE MANUAL WITH IMPORTANT WARNING & SAFETY INFORMATION. PLEASE SAVE THESE INSTRUCTIONS. Approximate assembly time: 20 minutes Tools needed for assembly: Phillips head screwdriver FOR OUTDOOR USE ONLY...
-
Page 2: Important Safeguards
WARNING THIS MANUAL CONTAINS IMPORTANT INFORMATION NECESSARY FOR THE PROPER AND SAFE USE OF THIS UNIT. READ AND FOLLOW ALL WARNINGS AND INSTRUCTIONS BEFORE USING GRILL AND DURING USE. FAILURE TO FOLLOW THESE WARNINGS AND INSTRUCTIONS PROPERLY COULD RESULT IN FIRE OR EXPLOSION THAT COULD CAUSE PROPERTY DAMAGE, PERSONAL INJURY OR DEATH. - Page 3 IMPORTANT SAFEGUARDS • Do not touch metal parts of grill until it has completely cooled (about 45 minutes) to avoid burns, unless you are wearing protective gear (BBQ mittens, pot holders, etc.) • Do not alter this grill in any manner. •...
- Page 4 TOLL FREE 1-866-475-5180 (Monday–Friday, 8:30 am–4:30 pm, CST). NOTE : DO NOT RETURN UNIT TO THE STORE BEFORE CALLING THE TOLL FREE NUMBER. Do not dispose of your cartons until you are completely satisfied with your new Smoke Hollow grill.
-
Page 5: Parts And Tool List
Description Quantity Part # Thermometer 205-1 Thermometer Bezel 205-2 Description Quantity Part # Hood 105-1 Burner 105-5 Hood Pivot Pin 205-3 Regulator/Valve 205-14A Hood Pivot Pin Nut (not shown) 205-4A Grill Firebowl 105-6 Hood Handle Bezel 205-5... -
Page 6: Grill Assembly
Grill Assembly 1. Hood Handle Assembly Instructions: Place a Handle Bezel between each end of the handle and the grill hood then insert a 1/4-20 x .50” Bolt through the inside of the hood into each end of the handle. Tighten the bolts. 2. - Page 7 Grill Assembly 3. Igniter Housing Assembly Instructions: A. Thread the Electrode Wire through the hole in the Igniter Housing and attach the end onto the pin at the bottom end of the Piezo Igniter. B. Align the holes in the Igniter Housing with the threaded holes in the firebowl end. Insert Four 5/32 x .31”...
-
Page 8: Before Using Your Lp Gas Grill
Before Using Your LP Gas Grill Installation Codes WARNING To reduce the risk of serious bodily injury or death from fire or explosion: — This installation must conform with local codes or, in the absence of local codes, with either the National Fuel Gas Code, ANSI Z223.1/NFPA 54 Natural Gas and Propane Installation Code, CSA B149.1, or Propane Storage and Handling Code, B149.2 or the Standard for Recreational Vehicles, ANSI A 119.2/NFPA 1192 and CSA Z240 RV Series, recreational Vehicle Code, as applicable. -
Page 9: Connecting Lp Gas Cylinder
Before Using Your LP Gas Grill Connecting LP Gas Cylinder 1. Purchase 1lb. LP Gas cylinder at your local retailer. 2. Turn the regulator knob to the “Off” position. 3. Remove protective cap from regulator opening. Remove plastic cap from top of propane cylinder. Save cylinder cap for replacement on cylinder if gas remains in cylinder after use. -
Page 10: Lighting The Grill
Lighting the Grill WARNING To reduce the risk of serious bodily injury or death from fire or explosion: — Open Hood before lighting the grill to release trapped gas. — During failed lighting attempts, or if the Burner goes out during operation, turn Control Knob “Off” to dissipate any accumulated gas. -
Page 11: Manually Lighting The Grill
Manually Lighting the Grill Match 1. Open the Hood. IMPORTANT: Make sure Regulator Knob is turned “OFF”. 2. While holding a lit match near the burner (Fig. 4), push the Regulator Knob in and turn 270 degrees (or 3/4 turn) counterclockwise to the High position. If the Burner goes out during operation, turn Regulator Knob to the “Off”... -
Page 12: Cooking On The Gas Grill
Cooking On the Gas Grill WARNING To reduce the risk of serious bodily injury or death from fire, explosion or burn hazard: — Never use charcoal or lighter fluid in your gas grill. Keep this outdoor cooking appliance clear and free from combustible materials, gasoline, and other flammable vapors and liquids. -
Page 13: Warming Rack
Controlling Flare-Ups: Flare-ups are part of cooking meats on a grill. This adds to the unique flavor of barbecued food. However, excessive flare-ups can overcook your food and create a dangerous situation for you and your grill. Excessive flare-ups may result from large amounts of fat on the food being cooked or the build up of grease in the grill. -
Page 14: Care And Maintenance
Care and Maintenance Cleaning the Grill WARNING To reduce risk of injury from laceration hazard, wear protective gloves when handling parts with sharp edges. Drip Tray: Remove the Drip Tray under the grill bowl after the grill has cooled completely. Scrape away food and fat residue from the Drip Tray. -
Page 15: Troubleshooting
Troubleshooting Problem Possible Cause Solution Gas leaking from LP Gas Cylinder Mechanical failure due to rust or mishandling Replace LP Gas Cylinder Gas leaking between LP Improper installation, connection not tight, Remove LP Gas Cylinder. Re-install correctly and tighten. Replace Gas Cylinder and Regulator failure of seal on LP Gas Cylinder Cylinder if damaged. -
Page 16: Limited Warranty
Limited Warranty This Smoke Hollow ® grill is guaranteed against broken or damaged parts at time of purchase. All parts carry a 1-year limited warranty. Paint is guaranteed to be free of defects for 90 days except for rust, which may appear after repeated use.
Need help?
Do you have a question about the 105 and is the answer not in the manual?
Questions and answers