Table of Contents
Advertisement
RF KEY FOB PROGRAMMING STEPS
Q-3 SELECT FOB # (1-8)
Up to eight wireless 4‐button key fobs can be used
with each Control Panel. Key fobs reports as
sensors 51‐58. The options for each Fob are
programmed with sub‐option questions.
•
Begin by entering the Fob number or select it
using the ← or → arrows.
•
Program the key fobs by using ↑ and ↓
arrows to select the sub‐options.
To skip RF Key Fob programming, press
NOTE:
Skip to jump from question Q‐3 to
question Q‐4 (RF keypad programming).
See "RF Keypad Programming Steps" on
page 40.
Select Fob (#) used (0-1)
DEFAULT: Unused (0)
Key fobs can be used with the Control Panel or not.
•
The default (0) sets all key fobs as unused (0).
•
To enable programming for this Key Fob, select
used (1).
Select Key Fob (#) equipment code
(0-9999)
DEFAULT: (0000) other
The Key Fob equipment code defines the sensor's
manufacturer and type.
•
The default is (0000) other.
•
Select (0866) KEY2‐345 4‐button Key Fob
remote for a 2GIG‐KEY2 Key Fob remote.
•
Select (0577) Existing Key Fob remote for an
existing Key Fob remote.
Only 2GIG‐KEY1‐345 or 2GIG‐KEY2‐345
NOTE:
key fobs can be used with this system.
Enter Key Fob (#) other equipment
code (0-9999)
DEFAULT: 0
This question is only displayed if
NOTE:
"(0000) other" is selected for a Key Fob's
equipment code.
•
The equipment code is a 4‐digit code that is
assigned to the model of Key Fob being used.
38
©2013 2GIG Technologies Inc. All Rights Reserved.
•
Enter the equipment code number for the Key
Fob.
Enter Fob (#) serial number
(7 digits)
DEFAULT: 0000000
Key fob serial numbers can be manually entered or
learned from the fob.
•
For manual entry, enter the fob number that
was logged for the fob being programmed. Use
the Shift button to access alpha characters.
•
For automatic entry, press Shift, then press
Learn. The Control Panel will wait for a fob
transmission. Trigger the fob being
programmed and the Control Panel will learn
the fob's serial number.
Select Fob (#) equipment age (0-1)
DEFAULT: New (0)
The Control Panel can be used with new or existing
key fobs.
•
If this fob is new for the installation, leave the
default of new(0).
•
If this fob is already installed, select existing
(1).
Select Fob (#) emergency key (0-4)
DEFAULT: Disabled (0)
Pressing the
and buttons on a key fob at the
same time for 5 seconds can trigger an emergency
alarm.
•
The default (0) disables the emergency
function for this Fob.
•
To enable the emergency function for this Fob,
select 1 of the 4 options:
•
(0) disabled
•
(1) auxiliary alarm
•
(2) audible alarm
•
(3) silent panic
•
(4) fire
Advertisement
Table of Contents
Need help?
Do you have a question about the Go Control and is the answer not in the manual?
Questions and answers