Table of Contents
Advertisement
Control TV Volume
Use this procedure to change from having the
remote adjust the volume of an audio receiver
or amplifier to having the remote adjust the TV's
volume. When the remote control is set up to
operate your TV, the MUTE and VOLUME buttons
adjust your TV volume when in SAT mode.
1
2
3
4
5
Make sure the remote controls the TV's
volume in other modes:
6
7
8
Press and hold TV until all
Mode buttons are lit, then
release it. The TV mode
button blinks.
Press POUND (#).
Press the plus (+) side of the
VOLUME button.
Press the 0 number button.
Press POUND (#). The TV
mode button flashes three
times.
Press SAT.
Press the plus (+) and minus
(-) sides of the VOLUME
button.
Your TV's volume changes,
and the TV mode button
lights.
22
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 20.1 and is the answer not in the manual?
Questions and answers
I have a 21.1 IR/UHF PRO model remote and it has suddenly stopped working DISH. The batteries are new. The remote still operates the tv just fine. But it doesn't seem to communicate with the Dish receiver at all. I can't even get "system wizard" to open on the tv by holding "0." I think I may have pushed something by mistake as it was working this morning and seemingly just suddenly stopped. How can I fix this probelm?
If your Dish Network 20.1 remote stopped working with the receiver but still operates the TV, follow these steps to fix it:
1. Check the Batteries: Replace the remote batteries if they are low.
2. Use System Wizard:
- Press and hold the 0 button until the System Wizard message appears.
- Follow the on-screen instructions to restore remote settings.
- Select Continue to return to Live TV.
3. Manually Reconnect the Remote:
- Turn on the receiver and TV.
- Press the SYSTEM INFO button on the front of the receiver.
- Confirm that the System Info screen appears.
- Press the RECORD button on the remote to re-link it with the receiver.
If the remote still does not work with the receiver, ensure there is a clear line of sight between them or, if using UHF mode, confirm the UHF/IR switch is set correctly.
This answer is automatically generated