DeWalt DC509 User Manual page 17

Description (fi g. A)
WARNING: Never modify the power tool
or any part of it. Damage or personal
injury could result.
INTENDED USE
The DC509/DC519 heavy-duty flashlights are
designed to operate on 36 V or 28V battery packs
and can be used as a handheld model or as a
standing model. DO NOT use under wet conditions
or in presence of flammable liquids or gases.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
1 On/off switch
2 Base
3 Flexible tube
4 Head
5 Lens
6 Lens holder
7 Battery pack (not included)
Electrical safety
Always check that the battery pack power
corresponds to the voltage on the rating plate.
Also make sure that the voltage of your charger
corresponds to that of your mains.
Assembly and adjustment
WARNING:
• Prior to assembly and adjustment,
always remove the battery pack.
• Always switch off the tool before
inserting or removing the battery pack.
• Before using the tool, make sure the
battery pack is properly seated.
Battery pack (fig. B)
Battery type
The tool will operate on battery packs of 36V or
28V. Refer to the table near the end of this section
for a selection of applicable battery packs.
WARNING: Use only D
packs and chargers.
Fitting and removing the battery pack
Make sure the battery pack is properly seated.
• To fit the battery pack (7), line it up with the
receptacle on the tool. Slide the battery pack into
the receptacle and push until the battery snaps
into place.
• To remove the battery pack, push the release
button (8) while at the same time pulling the
battery pack out of the receptacle.
Battery pack condition
• Make sure your battery pack is (fully) charged.
If the battery pack does not produce sufficient
power, charge the battery pack following the
instructions in the manual of the charger.
Replacing the light bulb (fig. C)
• Unscrew the lens holder (6) and remove it.
• Simply pull out the bulb (9) and insert a new one.
• Reinstall the lens holder (6).
Positioning the head (fig. D)
Your flashlight can be used as a standing model or
as a handheld model. When used as a handheld
model, the tool can be carried at the flexible tube.
When used as a standing model, the head can be
positioned by means of the flexible tube to adjust
the direction of the beam of light.
• Hold the base (2) with one hand and with the
other hand slide the head (4) off the base.
• Mould the tube (3) as necessary position the head.
• To refit the head, hold the head in front of the base
and slide the head on until it clicks into place.
Instructions for use
Switching on and off (fig. A)
• To switch the tool on, slide the on/off switch (1)
to the left.
• To switch the tool off, slide the on/off switch (1)
to the right.
WALT battery
E
E N G L I S H
WARNING: Always observe the safety
instructions and applicable regulations.
15