Uninstalling Rockbox; Automatic Uninstallation; Manual Uninstallation; Troubleshooting - SanDisk Sansa Clip v2 Manual

Chapter 2. Installation
installed over your current build.
The bootloader only changes rarely, and should not normally need to be updated.
Note: If you use Rockbox Utility be aware that it cannot detect manually installed
components.

2.5. Uninstalling Rockbox

Note: The Rockbox bootloader allows you to choose between Rockbox and the original
firmware. (See section

2.5.1. Automatic Uninstallation

You can uninstall Rockbox automatically by using Rockbox Utility. If you installed
Rockbox manually you can still use Rockbox Utility for uninstallation but will not be
able to do this selectively.

2.5.2. Manual Uninstallation

Copy an unmodified original firmware to your player, and then reboot into the Sandisk
firmware. See section
If you wish to clean up your disk, you may also wish to delete the .rockbox directory
and its contents. Turn the Sansa off. Turn the player back on and the original Sansa
software will load.

2.6. Troubleshooting

"File Not Found" If you receive a "File Not Found" from the bootloader, then the
bootloader cannot find the Rockbox firmware. This is usually a result of not
extracting the contents of the .zip file to the proper location, and should not
happen when Rockbox has been installed with Rockbox Utility.
To fix this, either install Rockbox with the Rockbox Utility which will take care
of this for you, or recheck the Manual Install section to see where the files need to
be located.
The Rockbox manual
3.1.3 (page 20) for more information.)
3.1.3 (page 20) for more information.
(version 3.14)
18
Sansa Clip v2