Bootloader Installation From Windows - SanDisk Sansa Clip v2 Manual

Chapter 2. Installation
3. Take the .zip file that you downloaded and use the "Extract all" command of
your unzip program to extract the files onto
Note: The entire contents of the .zip file should be extracted directly to the root of
your player's drive. Do not try to create a separate directory on your player for the
Rockbox files! The .zip file already contains the internal structure that Rockbox needs.
If the contents of the .zip file are extracted correctly, you will have a directory called
.rockbox, which contains all the files needed by Rockbox, in the main directory of your
player's drive.
Installing the bootloader
In order to install the bootloader, you will need to download the following files:
An original firmware (OF) from
Clip-Firmware-01-01-35-amp-02-01-35-Release/td-p/144965
The bootloader:
bootloader-clipv2.sansa
The version of mkamsboot for your operating system from
org/bootloader/sandisk-sansa/mkamsboot/

2.2.3. Bootloader installation from Windows

1. Create a folder called "rbinstall" on your desktop, and then extract the OF, the
bootloader and mkamsboot into it.
2. Open a new command prompt, and navigate to the "rbinstall" folder.
3. Run mkamsboot.exe, passing the name of the OF and bootloader files that you
downloaded, in addition to a name for the output file.
mkamsboot.exe m30pa.bin bootloader-clipv2.sansa patched.bin
If mkamsboot.exe does not report success, then retry or abort.
4. Copy the output file ("patched.bin" in the example given above) to the root of
the device and rename it to the same name as the OF file you downloaded earlier
("m30pa.bin"
The Rockbox manual
http://forums.sandisk.com/t5/Clip-Clip/Sansa-
http://download.rockbox.org/bootloader/sandisk- sansa/clipv2/
above).
(version 3.14)
your player.
http://download.rockbox.
Code
16
Sansa Clip v2