Figure 1-9 Dome Housing Component For The Sony Snc-Rx550N/W-Mt Camera - Motorola MOTOMESH 1.2 Setup And Configuration Manual

Chapter 1: Overview
D.) Prior to installing the camera into the housing, attach the power and alarm cables per
E.) Line up the plate you have installed on the camera with the correct holes in the housing.
Figure 1-9
F.) Place the safety line on the housing to the dome cover.
G.) Line up the dome cover onto the housing and install per instructions.
H.) Pull the screw type fitting with set screws off the outdoor housing and screw this onto the
I.) Setup the AC source and load (camera) wiring for the PELCO power supply per
J.) You will now have to power your unit for any required pre-configurations (see
2. Prepare the Gooseneck with the two clamps (if using the pole mount and straps prepare at site
location).
6881011Y68-B October 2006
instructions.
Attach the camera to the housing.
Dome Housing Component for the Sony SNC-RX550N/W-MT Camera
gooseneck.
instructions included. Make the adequate slack for both the AC source and load/Camera.
Note that you will need to be able to have enough wire on the load side to run from the
power supply at its installed location, through the gooseneck, to the camera's outdoor
housing.
instructions).
TIP FROM THE FIELD: You will need a crossover Ethernet Cable to complete the
Camera IP Address Configuration Using a Laptop
guide.
section located in Chapter 2 of this
1-10