Troubleshooting; Intercom Failure; Intercom Reconnection; Fault Reset - Sena SMH5 MULTICOM User Manual

SMH5 MultiCom

14 TROUBLESHOOTING

14.1 Intercom Failure

When you try to start an intercom conversation with an intercom friend
who is already having a conference intercom with other riders or a mobile
phone call, you will hear a low tone double beep signifying an intercom
busy signal. In this case, you have to try again later.

14.2 Intercom Reconnection

If your intercom friend goes out of range while having an intercom
conversation, you may hear static noise and eventually the intercom will
be disconnected. In this case, the SMH5 MultiCom automatically tries
to reconnect the intercom every 8 seconds and you will hear high tone
double beeps until the intercom is reestablished. If you don't want to
make a reconnection, tap the Jog Dial to stop the attempt.
40

14.3 Fault Reset

When the SMH5 MultiCom is not working properly or is in faulty status
for any reason, you may reset by pushing the pin-hole reset button at the
back of the headset main unit. Insert a paperclip into the reset pin-hole
and press the reset button for a second with light pressure. The SMH5
MultiCom will be switched off, and you have to turn the system back on
and try again. However, this will not restore the headset to factory default
settings.