Installing The Software; Launching The Start Menu - GRAPHTEC CE6000 SERIES Setup Manual

Install the software housed in the attached DVD-ROM into the PC that is used.
This section explains how to install the software when using a Windows 10 (64 bit) operating environment.
•
Note
Upon installation, be sure to log on Windows using an account with administrator privileges on your computer.
If you have logged on using a standard user account, an [User Account Control] screen asking you to enter the
administrator account password may appear.
•
Supported OS
This software supports the following OS environments:
Windows 10 (32 bit/64 bit), Windows 8.1 (32 bit/64 bit), Windows 8 (32 bit/64 bit), Windows 7 (32bit/64bit),
(Plotter driver/Cutting Plotter Controller also supports Windows Vista.)
Mac OS X 10.11 to 10.7 / mac OS 10.12
(Graphtec Studio also supports Mac OSX 10.6.)
•
When Using Macintosh
Macintosh operating environments are supported by the following software.
Proceed with installation in accordance with your operating environment.
• Graphtec Studio : Software application that enables cutting data to be created through simple commands.
• Cutting Master 4 : Plug-in driver that can be directly operated from within Adobe Illustrator.
When checking the manual in the Macintosh operating environment, open the pertinent manual on the accompanying
DVD-ROM in the following sequence: [Mac] > [Manuals] > [English (Each language)] > [Manual According to Software].
•
Setup in a Windows operating environment

1. Launching the Start Menu

< When using the DVD >
After starting up Windows, insert the [USER GUIDE & SOFTWARE DVD] provided with the CE6000 into your computer's
DVD drive.
The below screen will appear before the Start Menu launches.
Continue with installation in accordance with the following procedures.
1
The start-up message of DVD drive is displayed. Click on the message.
* When setting up the DVD in the computer, this message will disappear after a few seconds.
2
DVD operation screen is displayed.
Select the "Run MultiSetup.exe" from the DVD operation screen.
* If the DVD operation screen is not displayed, select the set DVD drive from the Explorer.
Open the DVD and double-click on [MultiSetup.exe].

Installing the Software

Note that Adobe Illustrator must be installed on your computer prior to use.
14