Table of Contents
Advertisement
Chapter 6 – FIRMWARE
UPDATING THE FIRMWARE
To interface the Olivetti 3D S2 printer with the PC and carry out firmware updating, both the IDE Arduino
software and the U8glib library must be installed on the PC, the latter serving for display management as well
as providing the Repetier slicing software.
To perform firmware updating the following files / folders are necessary which can be found on the technical
content site
www.olinet.biz
Firmware Folder of Olivetti 3D S2 printer:
Display management library
IDE Arduino software:
Repetier slicing software:
Figure 6-1
Y118040-3
:
Service Manual
MK_S2-Olivetti
U8glib.zip
arduino-1.6.8-windows
setupRepetierHost_1_6_1
6-1
Advertisement
Table of Contents
Need help?
Do you have a question about the 3D S2 and is the answer not in the manual?
Questions and answers