Related Manuals for Durafly T-28 TROJAN
Summary of Contents for Durafly T-28 TROJAN
- Page 1 INSTRUCTION MANUAL (PNF) Please read this manual carefully before operating this plane.
-
Page 3: Table Of Contents
CONTENTS Introduction Specifications Contents Of Box Required To Complete Model Assembly Setting Up Your Model Model Flying Precautions Pre-flight Checks Flying Your T-28 Trojan T-28 Trojan TIPS Spare Parts Listing Trouble Shooting Contact Notes... -
Page 4: Introduction
T-28 Trojan screws together in just 6 easy steps, with multiple hatches allowing easy access to internal electronics. We went one step further and included a wooden camera holder allowing you to install your FPV equipment and experience the thrill of flying your T-28 Trojan in a whole different way! The Durafly T-28 Trojan, you deserve to have one. -
Page 5: Contents Of Box
REQUIRED TO COMPLETE MODEL: In its ‘Plug n Fly’ format the T-28 still requires some additional electronic components to get it ‘flight ready’. Durafly recommends the products below for optimum performance and great value. Available at hobbyking.com OrangeRx T-SIX 2.4GHz 6CH... -
Page 6: Assembly
ASSEMBLY 1. Locate the bag marked “Aileron” and “Flap”. Install aileron and flap control horns and rods for each side of the wing as shown. Ensure the servo horn is at 90 degrees to the wing when installing the rod. 2. - Page 7 3. Locate the bag marked “Elevator”Install horizontal tail, control horns and rods with the supplied bolts as shown. Ensure tail is firmly secured and aligned. 4. Locate the bag marked “Rudder” Install the control horns on the vertical tail. Connecting the pre installed control rods to the outer hold of the control horn.
-
Page 8: Propeller
5. Mount the wing to the fuselage with the supplied bolts. Make sure to feed servo wires into passage to fuselage compartment, ensuring no wires are pinched in the wing saddle. 6. The final stage of assembly is to mount propeller. Slide prop onto motor shaft, engaging molded hex detail on back of propeller to hex fitting on prop shaft. - Page 9 Congratulations, basic assembly of your T-28 Trojan is now complete. Please perform a final check on all screws, bolts and components, ensuring all are secure and firmly in place.
-
Page 10: Setting Up Your Model
Ailerons and Flaps Elevator Rudder 3. The T-28 Trojan handles very well in flight warbird high speed handling, trainer-like low speed. Before you fly your T-28 Trojan please follow the recommended settings below for optimum handling and performance.. Control throws:... - Page 11 2. Check control surfaces for proper movement with applicable stick input. A reversed control could lead to loss of control and damage to the model. 4. Linear power delivery is important to optimal flight performance. Calibrate the ESC using the instructions below when switching to a new transmiter.
- Page 12 5. The center gravity (CG) for the T-28 Trojan is approximately 50-60mm from the leading edge of the wing. Using the recommended Turnigy 4S 14.8V 2200mah LiPo, the correct CG can be attained quite easily due to the ample battery space. If using larger capacity batteries, you may need to shift the battery backwards more to attain the correct CG.
-
Page 13: Model Flying Precautions
MODEL FLYING PRECAUTIONS ● Select your flight area carefully. Always choose an open space that is unobstructed from trees and buildings and away from crowed areas. Avoid flying in area’s with roads, electric/telephone poles/wires and water near by or within close proximity to full size air traffic. ●... -
Page 14: Flying Your T-28 Trojan
Flying the T-28 Trojan The Durafly T-28 Trojan not only looks good as the original, but flies just as well; capturing perfectly those excellent flight qualities that established the it as such a popular RC sport model all those years ago. -
Page 15: T-28 Trojan Tips
T-28 Trojan TIPS When handling the T-28 Trojan it is recommended that you do so only from the leading edge of the wing to avoid wear to the edges of the fuselage. The T-28 Trojan by design has flat sides and hard edges that are vulneralbe as painted EPO. -
Page 16: Spare Parts Listing
SPARE PARTS T-28 Trojan Fuselage Main Wing Set Horizontal Tail Part No: Part No: Part No: 9306000235-0 9306000236-0 936000237-0 Cowl Propeller Motor Part No: Part No: Part No: 9306000238-0 9306000239-0 9306000240-0 Canopy Nose Gear Retract Main Gear Retract Set Part No:... -
Page 17: Trouble Shooting
TROUBLE SHOOTING: Problem Cause Solution 1. Charge the batteries. 1. Battery is not fully charged. 2. Install a full charged battery. 2. Transmitter battery low. 3. Check for connection 3. Motors not connected. between the ESC and motor. 4. Replace motor. Motor does 4. -
Page 18: Contact
If you wish to contact us directly please email: durafly@hobbyking.com... - Page 20 facebook.com/durafly...
Need help?
Do you have a question about the T-28 TROJAN and is the answer not in the manual?
Questions and answers