Panasonic KX-TVM50 Installation Manual page 39

Switch Position
8
9
10
11
12
13
14
15
1 If the selected language has no prompts, no prompts will be heard.
*
When setting the Mode Switch to any position (except 0):
1.
Disconnect the port cables from the VPS.
2.
Turn the power switch off.
3.
Set the Mode Switch.
4.
Turn the power switch back on.
5.
Connect the port cables.
6.
Confirm that the Run Indicator blinks the same number of times as the Mode Switch position
(e.g., 5 blinks for switch position 5, etc.).
•
7.
Turn the power switch off at the VPS.
8.
Set the Mode Switch to position 0.
9.
Turn the power switch back on at the VPS.
LAN Port (Optional for KX-TVM50)
Used to access the VPS over an Ethernet network.
KX-TVM200 only
Initialises the VPS. All settings are reset to their default values. Recorded
messages and customised prompts are erased. All System Prompts
are reset to their defaults.
CAUTION
All user-recorded prompts are erased.
Reserved
KX-TVM50 only
Puts the VPS in APT Integration mode. Auto Configuration starts and all
ports are set to provide Automated Attendant service.
KX-TVM50 only
Puts the VPS in APT Integration mode. Auto Configuration starts and all
ports are set to provide Voice Mail service.
Primary Language will be set to use Language 1 prompts.*
Primary Language will be set to use Language 2 prompts.*
Primary Language will be set to use Language 3 prompts.*
Reserved
This may take several minutes. The Alarm Indicator and Run Indicator will first blink
intermittently before the Run Indicator blinks to indicate the Mode Switch position.
2.3 Names and Locations
Operation
Installation Manual
1
1
1
39