Installation Instructions - Noam NUTV4 Owner's Manual

INSTALLATION INSTRUCTIONS:

STEP1
YOU'LL NEED: A SCREW DRIVER
Remove the two screws from the bracket
to separate the Speaker case and the
bracket.
STEP2
YOU'LL NEED: THE RUBBER PAD TO
ADJUST THE SIZE OF THE MOUNTING
BRACKET
Remove the backing from the Rubber
Pad and stick on the mounting surface
NOTE
Rubber Pad in 3 Specification:
Pad No.1: 76X30X2mm* 6PCS
Pad No.2: 140x30x3mm*4PCS
Pad No.3: 38x30x3mm*4PCS
Attention: Please Cut Pad No.2 into the Size You Need for Each Mounting Bar Size
Note: pad No.3 is an extra small pad that can be used in case you need an extra spacer for a better grip
Remove Both
Screws
Remove backing
From Rubber Pad
& Push Down
Rubber Pad Quantity You Need for Each Mounting Dimension:
2" Bar: Pad No.1* 2PCS
1.75" Bar: Pad No.1*2PCS and Pad No. 2*1PC
1.5" Bar: Pad No.1*2PCS and Pad No. 2*2PCS
1.25" Bar: Pad No.1*2PCS and Pad No. 2*3 PCS
3
STEP3
YOU'LL NEED: 2 SCREWS, MOUNTING
BRACKET, RUBBER PAD AND THE
MOUNTING BAR
Mount the speaker on the bar where
you want. The mounting dimension is
available from 1.25"~ 2".
STEP4
FINISHED INSTALLATION !!
BEGIN ENJOYING YOUR MUSIC !!
Screws
Mounting
Bracket
Rubber pad
Mounting
Bar