Panasonic KV-S1025C SERIES Service Manual page 69

9.3.6. Test
Item
LED 1. Click "LED" on the main menu.
2. Click "START" on LED dialog box to start the LED Test
continuously until clicking "STOP".
3. Click "Close" to get back to the main menu.
Key / Sensor 1. Click "Key / Sensor" on the main menu.
2. Check the sensor status on the Key / Sensor dialog
box.
3. Click "Close" to get back to the main menu.
Conveyor Motor 1. Click "Conveyor Motor" on the main menu.
2. Click "START" on "Conveyor Motor" dialog box to start
continuous Conveyor Motor rotation until clicking "STOP".
3. Click "Close" to get back to the main menu.
Feed 1. Set documents on the Feed Tray.
2. Click "Feed" on the main menu.
3. After setting each "Test Condition", click "START" on
"Feed" dialog box to start feeding documents.
4. According to the message on the display, finish the test.
(Click "STOP" on "Feed" dialog box to stop the test on the
way of the feeding, as required.)
5. Click "Close" to get back to the main menu.
Sleep Mode 1. Click "Sleep Mode" on the main menu.
2. Click "START" on "Sleep Mode" dialog box to enter into the
sleep mode.
3. Click "STOP" to get out of the sleep mode.
4. Click "Close" to get back to the main menu.
Operation
69
Default Remarks
— Used to test the LEDs
(Green, Red) on the front
panel by turning on/off
periodically
(Green: ON, Red: OFF→
Green: OFF, Red: ON→
Green: ON, Red: ON→
Green: ON, Red: OFF→ .....)
—
—
—
—