CONNECT TO THE L60
•
View all of the L60 metering values
•
View the L60 protection summary
•
Generate a service report
3.8.2 Use Quick Connect via the front panel RS232 port
To connect to the UR from a computer using a serial cable:
1.
Connect a nine-pin to nine-pin RS232 serial cable to the computer and the front panel RS232 port.
2.
Verify that the latest version of the EnerVista UR Setup software is installed (available from the GE EnerVista DVD or
online from http://www.gegridsolutions.com/multilin). See the software installation section if not already installed.
3.
Start the EnerVista UR Setup software, or in EnerVista Launchpad select the UR device to start the software.
4.
Click the Quick Connect button to open the window.
3
5.
Select the serial Interface and the communications port (COM Port) from the drop-down lists, then click Connect. The
COM Port is that of the computer.
6.
The EnerVista software creates a site named "Quick Connect" with a corresponding device also named "Quick
Connect" and displays them in the Online Window. Expand the sections to view data directly from the UR device. Use
the Device Setup button to change the site name.
Each time that the EnerVista UR Setup software is initialized, click the Quick Connect button to establish direct
communications to the L60. This ensures that configuration of the EnerVista UR Setup software matches the L60 model
number.
3.8.3 Use Quick Connect via a rear Ethernet port
To connect to a UR using an Ethernet cable:
1.
In the EnerVista software, click the Quick Connect button. The window opens.
3-58
Figure 3-61: Quick Connect window to access a device
L60 LINE PHASE COMPARISON SYSTEM – INSTRUCTION MANUAL
CHAPTER 3: INSTALLATION