Adjusting The Power Tool Prior To Use - Hitachi C 15 FB Handling Instructions Manual

English
2. Power switch
Ensure that the power switch is in the OFF position. If the plug is connected to a power
receptacle while the power switch is in the ON position, the power tool will start operating
immediately, inviting serious accident.
3. Extension cord
When the work area is removed from the power source, use an extension cord of suffi cient
thickness and rated capacity. The extension cord should be kept as short as practicable.
4. When the tool is shipped, its movable parts are fi xed by the fi xing pin. Move the handle a
little and remove the pin by pulling it as illustrated in Fig. 1.
5. The lower guard is to protect the operator from
coming in contact with the saw blade during
operation.
Should the lower guard not function smoothly, DO
NOT OPERATE THE TOOL.
In addition, the lower guard should be wiped clean
of chips and dust to permit clear visibility of the saw
blade.
6. Ascertain that the spindle lock used for installation
and removal of the saw blade has been released.

ADJUSTING THE POWER TOOL PRIOR TO USE

1. Saw blade height adjustment (Fig. 3)
Loosen the lock nut on the adjusting bolt for cutting
and turn the adjusting bolt while lowering the handle.
The saw blade goes up when the adjusting bolt is
turned counterclockwise and down when it is turned
clockwise.
CAUTION
Ensure the height is adjusted securely so that the
saw blade does not contact the turntable.
During transportation
(Fit the pin onto the deep slot)
Fixing Pin
Pull, disengage and rotate the
pin a 1/4 round to remove it.
During cutting operation
(Fit the pin onto the shallow slot)
Fig. 1
26
Lower guard
Fig. 2
Fig. 3
10 mm Bolt