Bus Differential - GE B90 Instruction Manual

5 SETTINGS

PATH: SETTINGS GROUPED ELEMENTS
 BUS ZONE 1
 DIFFERENTIAL
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
Up to four zones of bus differential protection are provided, depending on the software options. The operation of these ele-
ments is completely dependent on the dynamic bus replica, which must be defined first. Both restrained (biased) and unre-
strained (unbiased, instantaneous) bus differential protection functions are provided for each bus differential zone.
The biased bus differential function has a dual-slope operating characteristic (see figure below) operating in conjunction
with saturation detection and a directional comparison principle (refer to the Bus zone 1 differential scheme logic figure in
this section).
GE Multilin
 
SETTING GROUP 1(6)
BUS ZONE 1 DIFF
FUNCTION: Disabled
BUS ZONE 1 DIFF
PICKUP: 0.100 pu
BUS ZONE 1 DIFF
LOW SLOPE: 25%
BUS ZONE 1 DIFF
LOW BPNT: 2.00 pu
BUS ZONE 1 DIFF
HIGH SLOPE: 60%
BUS ZONE 1 DIFF
HIGH BPNT: 8.00 pu
BUS ZONE 1 DIFF
HIGH SET: 15.00 pu
BUS ZONE 1 DIFF
SEAL-IN: 0.400 s
BUS ZONE 1 DIFF SUPV:
On
BUS ZONE 1 DIFF TRIP:
Off
BUS ZONE 1 DIFF BLK:
Off
BUS ZONE 1 DIFF
TARGET: Latched
BUS ZONE 1 DIFF
EVENTS: Disabled
B90 Low Impedance Bus Differential System
5.5 GROUPED ELEMENTS

5.5.3 BUS DIFFERENTIAL


BUS DIFFERENTIAL BUS ZONE 1(4) DIFFERENTIAL
Range: Disabled, Enabled
Range: 0.050 to 6.000 pu in steps of 0.001
Range: 15 to 100% in steps of 1
Range: 1.00 to 30.00 pu in steps of 0.01
Range: 50 to 100% in steps of 1
Range: 1.00 to 30.00 pu in steps of 0.01
Range: 0.10 to 99.99 pu in steps of 0.01
Range: 0.000 to 65.535 s in steps of 0.001
Range: FlexLogic™ operand
Range: FlexLogic™ operand
Range: FlexLogic™ operand
Range: Self-reset, Latched, Disabled
Range: Disabled, Enabled
5
5-85