Appendix A
Installing and Replacing the SSM
Attach the screws to secure the SSM to the chassis.
Step 6
Enter the hw-mod mod 1 reset command in privileged EXEC mode to reset the SSM.
Step 7
Check the LEDs. If the SSM is installed properly, the POWER LED is solid green and the STATUS LED
Step 8
flashes green.
Connect one end of the RJ-45 cable to the port and the other end of the cable to your network devices. For
Step 9
more information, see
78-17374-01
Figure
3-15.
Installing and Replacing the SSM
Cisco ASA 5500 Series Hardware Installation Guide
A-11