Table of Contents
Advertisement
CHAPTER 3: INTERFACES
869 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL
7.
Select the complete path, including the new directory name, where the EnerVista 8
Series Setup software is being installed.
8.
Click on Next to begin the installation. The files are installed in the directory indicated,
the USB driver is loaded into the computer, and the installation program automatically
creates icons and adds the EnerVista 8 Series Setup software to the Windows start
menu.
9.
The 869 device is added to the list of installed IEDs in the EnerVista Launchpad
window, as shown below.
If you are going to communicate from your computer to the 869 Relay using the USB
port:
10. Plug the USB cable into the USB port on the 869 Relay then into the USB port on your
computer.
11. Launch EnerVista 8 Series Setup software from LaunchPad.
12. In EnerVista > Device Setup:
SOFTWARE INTERFACE
3–17
Advertisement
Table of Contents
