Pioneer PRO-810HD Service Manual page 196

1
INSTALLATION OF THE UNIT UNIT
Installation using the optional PIONEER stand or
installation bracket
A
• Please be sure to request installation or mounting of this unit
or the installation bracket by the dealer where purchased.
• When installing, be sure to use the bolts provided with the
stand or installation bracket.
• For details concerning installation, please refer to the
instruction manual provided with the stand or installation
bracket.
Installation using accessories other than the
PIONEER stand or installation bracket (sold
separately)
• When possible, please install using parts and accessories
manufactured by PIONEER. PIONEER will not be held
B
responsible for accident or damage caused by the use of parts
and accessories manufactured by other companies.
• For custom installation, please consult the dealer where the
unit was purchased.
C
a hole
D
Rear view diagram (PRO-1010HD)
E
Rear view diagram (PRO-810HD)
F
196
1
2
Air vents (fan)
a hole
Center line
Air vents (fan)
a hole
a hole
Center line
PRO-1010HD
2
3
Wall-mount installation of the unit
This unit has been designed with bolt holes for wall-
mount installation, etc. The installation holes that can be
used are shown in the diagram below.
Be sure to attach in 4 or more locations above and
•
below, left and right of the center line.
Use bolts that are long enough to be inserted 1/2 inch
•
(12 mm) to 11/16 inch (18 mm) into the main unit from
the attaching surface for both a holes.
Refer to the side view diagram below.
As this unit is constructed with glass, be sure to install
•
it on a flat, unwarped surface.
CAUTION
To avoid malfunction, overheating of this unit, and possible fire
hazard, make sure that the vents on the main unit are not
blocked when installing. Also, as hot air is expelled from the air
vents, be careful of deterioration and dirt build up on rear surface
wall, etc..
CAUTION
Please be sure to use an M8 (Pitch = 1.25 mm) bolt (Only
this size bolt can be used).
Main unit
Center line
Side view diagram
CAUTION
This display unit weighs at least 67 lbs (30 kg) and has
little front-to-back depth, making it very unstable when
stood on edge. As a result, two or more persons should
cooperate when unpacking, moving, or installing the
display.
Center line
CAUTION
This unit incorporates a thin design. To ensure safety if
vibrated or shaken, please be sure to take measures to
prevent the unit from tipping over.
3
4
Attaching surface
Installation
bracket, etc..
a hole
Bolt
1/2 inches (12 mm) to
11/16 inches (18 mm)
4