Motorola MOTORIZR Z6tv Service Manual page 56

Disassembly
G
56
43. Place the slider outer over the fixture and insert the pins through the holes on
the slider outer and press down on the outer so that it makes contact with the
adhesive on the keypad flex.
44. Once the Keypad flex is applied to the slider outer, rub the air pockets out of
the Mylar and actuator sheet. This will improve the placement of the keypad.
45. Inspect the flex on opposite side for damage during the assembly process.
46. Assemble the slider keypad as shown. First insert the bottom tabs into the
housing slots then cam it over and insert the side tabs into the housing. Lay
the keypad into the designated pocket on slider housing. The bending tabs
should be inserted into the side slots. Be careful that the bending tabs do not
damage the EL Panel during assembly
Do not scratch the EL panel and the slider front housing with the metal keypad tabs.
Figure 67. Installing the Slider Keypad
February 19, 2008
Z6m/Z6tv CDMA
.
v463431
6809513A80-B