Table of Contents
Advertisement
Terminal Setup
This powerful software management tool is described in detail in Auto-Configuration.
For now, it is sufficient simply to use it for assignment of the initial terminal
configuration and IP address, both of which can be easily changed later. Ensure that all of
the check boxes are checked as shown above.
To assign terminal IP addresses automatically over the wireless network, check all of the
boxes as shown above. Then click on the
Addresses
button and enter the desired range
in the
From
and
To
boxes as shown in the following figure.
After setting the address range, click on
to return to the Auto-Configuration screen
OK
and then click on the box next to
.
Terminal/Group Manager
•
2-9
Supported Equipment Manual
May, 2006
Advertisement
Table of Contents
