Using The Protocol Editing Tool; General; Protocol Configurations; Starting The Potocol Editing Tool - ABB CAP 505 User Manual

1MRS751982-MUM
2.
2.1.
2.2.
2.3.
)LJ  6WDUWLQJ WKH 3URWRFRO (GLWLQJ 7RRO
ABB Automation
Protocol Editing Tool
User's Guide

Using the Protocol Editing Tool

General

This chapter describes the different menus and functions in the Protocol Editing
Tool and how to use these.

Protocol configurations

There are three kinds of protocol configurations. These configurations are stored in
three different places:
• "Work configuration", which is stored in the \POD directory under the object
home directory, e.g. in ..\OBJ0001\POD.
• "User templates", which are stored in the \POD directory under the project
directory OBJ000\Misc\. This is a common place where the users should save
custom configurations.
• "Standard templates", which are included in the object type configurations and
they are distributed with the SM/RED package. Users cannot save the custom
POD configuration to these locations.
Starting the Protocol Editing Tool
The Protocol Editing Tool is started from the Project Navigator in CAP 505 (see
Figure 2.3.-1).
If a work configuration is found in the project folder, this is opened automatically at
start-up.
CAP 505
2. Using the Protocol Edit-
ing Tool
2
3