Canon CS100 Instruction Manual page 42

NFC connect point
When holding the terminal close to Connect Station, do not drop the terminal on it or
push the terminal hard against it. Doing so may damage the built-in hard disk.
If a case etc. is attached to the terminal, connection may not be possible. In such a
case, detach the case, etc., and hold the terminal close to Connect Station.
Since the terminal may not be recognized readily, carefully hold the terminal close to
the NFC connect point on Connect Station while rotating the terminal horizontally.
Just holding the terminal close to Connect Station may not establish a connection. In
such a case, gently touch Connect Station with the terminal.
When Connect Station gives three short beeps and the power lamp blinks in red, check
whether Connect Station is connected to the access point, router, etc.
1
Operate the terminal to
connect to the access point,
router, etc. to which Connect
Station is connected.
2
Hold the terminal close to the
NFC connect point on Connect
Station.
Carefully hold the n on the
terminal close to the NFC connect
point on Connect Station.
Connect Station gives two short
beeps, and the Wi-Fi lamp blinks
twice. If the browser on the
terminal starts and the login
screen is displayed,
communication is established via
Wi-Fi even if the terminal is
moved away from Connect
Station.
3
Operate the terminal to log in
to Connect Station.
On the terminal screen, select
[OK].
The album list screen will appear
(p.43).
41