Battery Installation - Polaris RZR 170 Owner's Manual

MAINTENANCE
Battery

Battery Installation

Using a new battery that has not been fully charged can damage the
battery and result in a shorter life. It can also hinder vehicle
performance. Follow the battery charging instructions on page 84 before
installing the battery.
1. Ensure that the battery is fully charged.
2. Place the battery in the battery holder.
3. On conventional batteries, install the battery vent tube. The vent
tube must be free of obstructions and securely installed. Route the
tube away from the frame and vehicle body to prevent contact with
electrolyte.
Battery gases could accumulate in an improperly installed vent tube and
cause an explosion, resulting in serious injury or death. Always ensure
that the vent tube is free of obstructions and is securely installed as
recommended.
4. Coat the terminals with dielectric grease or petroleum jelly.
5. Connect and tighten the red (positive) cable first.
6. Connect and tighten the black (negative) cable last.
7. Verify that cables are properly routed.
8. Reinstall the driver's seat.
82