Table of Contents
Advertisement
● Lamp replace counter reset
● L L amp rep a e co o un er ese
Be sure to reset the lamp replace counter after the lamp is replaced. When the lamp replace counter is reset,
the LAMP REPLACE indicator stops lighting.
1
Turn the LCD Projection TV on, press the MENU
button, and the On-Screen Menu will appear. Select
the Setting Menu with the Point Up/Down button and
press the Point Right button to enter the sub-menu.
2
Select the Lamp counter reset item and then press the
OK button. The message "Lamp replace counter
Reset?" is displayed. Choose [Yes] and then press the
OK button.
3
Another confirmation dialog box appears and choose
[Yes] to reset the Lamp replace counter.
NOTE:
● Do not reset the Lamp replace counter without
implementation of lamp replacement. Be sure to reset the
Lamp replace counter only after replacing the lamp.
●
How to check Lamp Used Time
The LAMP REPLACE indicator will light orange when
the total lamp used time reaches 5000 hours. This is
to indicate that lamp replacement is required.
The total lamp used time is calculated by using the
below expression;
Total lamp used time = T
T
: used time in the Eco2 mode
eco
T
: used time in the Normal, Auto and Eco1
normal
mode
You can check the lamp replace counter following to
below procedure.
1
Press and hold the MENU and OK button on the TV
set for more than 3 seconds.
2
The LCD projection TV used time and lamp used
time will be displayed on the screen briefly.
+ T
l (1+1/2)
eco
norma
Lamp counter reset
Rear-projection TV used time
Counter
Rearprojection TV :
Lamp
Normal
Eco
Total
- 14 -
0175H
:
0050H
:
0100H
:
0175H
Total lamp used time
Advertisement
Table of Contents
