Precautions - Cognex DataMan 260 Reference Manual

Precautions

Observe these precautions when installing the Cognex product, to reduce the risk of injury or equipment damage:
This device requires the use of an LPS or NEC class 2 power supply (non-PoE device) or the use of a PoE Class
l
1 (PoE device).
Do not connect or disconnect this device from the I/O module or 15-pin USB adapter cable while the I/O module
l
or adapter cable is connected to a PC .
To reduce the risk of damage or malfunction due to over-voltage, line noise, electrostatic discharge (ESD), power
l
surges, or other irregularities in the power supply, route all cables and wires away from high-voltage power
sources.
Changes or modifications not expressly approved by the party responsible for regulatory compliance could void
l
the user's authority to operate the equipment.
Cable shielding can be degraded or cables can be damaged or wear out more quickly if a service loop or bend
l
radius is tighter than 10X the cable diameter. The bend radius must begin at least six inches from the connector.
Class A Equipment (broadcasting and communication equipment for office work): Seller and user shall be
l
notified that this equipment is suitable for electromagnetic equipment for office work (Class A) and can be used
outside the home.
This device should be used in accordance with the instructions in this manual.
l
All specifications are for reference purpose only and may be changed without notice.
l
53
Precautions