Cleaning Prior To Initial Use - Whirlpool 7LIECH-SSF-WL User Manual

CLEANING PRIOR TO INITIAL USE

To remove any odors or dust that may have accumulated during shipment, you may want
to clean the dispenser prior to first use.
DO NOT PLUG THE COOLER INTO AN ELECTRICAL POWER OUTLET AT THIS TIME.
Time Required for Set Up: 40 minutes.
1. Remove the bottle receptacle by turning it counter clockwise and
pulling up.
2. Remove the plastic baffle from inside the reservoir. Clean with
warm soapy water, rinse.
3. Fill the reservoir with a mixture of 1 gallon tap water and 1
teaspoon or unscented bleach (5.25% sodium hypochlorite).
4. Let sit for 30 minutes.
5. Dispense 1 cup of mixture through both faucets to clean out water
ways.
6. Place a 2 gallon or larger bucket under the drain plug in
the rear of the dispenser. Remove drain cap and drain
plug.
Reminder - Place the drain cap, drain plug and screw in
a safe location so that they will not be lost.
7. Once unit has completed draining, empty the bucket
and return it to under the drain cap.
8. Replace drain cap and drain plug.
9. Wipe the inside of the reservoir with a soft cloth.
10. Fill the reservoir with 1 gallon of tap water.
11. Dispense 1 cup of water through both faucets to rinse
out water ways.
12. Remove the drain cap and the drain plug.
Reminder - Place the drain cap, drain plug and screw in a safe location so that they will
not be lost.
13. Remove the water from the reservoirs by dispensing it from both taps into a pitcher.
14. Replace all parts. Reminder - Don't forget the drain plug and drain cap.
15. Complete the installation and follow the operation instructions indicated in this manual.
If your water has an off-taste, do not return the dispenser to store. Call 1-855-594-4755 for
assistance.
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-855-594-4755 for assistance.
Model # 7LIECH-SSF-WL: Page 9
To Remove Bottle
Receptacle