Maintenance And Cleaning; Troubleshooting - VonHaus 07/200 US Instruction Manual

Caution: Before carrying out maintenance, turn off the appliance and disconnect power plug.
We recommend the Dust Container is emptied after every use in order to maintain
optimum performance.
Switch OFF the vacuum cleaner with the ON/OFF Switch and disconnect the plug from the
mains.
Release the Dust Container by pressing the Release Button.
Ensure you are holding the Dust Container when you press the Release Button as it will detach from the main unit.
Empty the waste in the Dust Container into a waste basket, tap to remove all contents.
Replace the Dust Container.
Switch OFF the vacuum cleaner with the ON/OFF Switch and disconnect the plug from the
mains.
Release the Dust Container by pressing the Release Button.
Remove the HEPA Filter by pulling the rubber tab labelled "PULL"
Unfasten the velcro strip to remove the Protective Mesh Filter wrapped around the HEPA Filter.
Rinse both parts under cold, running water and allow to dry completely.
Wrap the Protective Mesh Filter around the HEPA Filter and use the velcro strip to secure.
Insert the Filters back in to the Dust Container.
Replace the Dust Container.
Caution: Before starting troubleshooting, stop the appliance and disconnect the power plug.
Problem...
Vacuum will not start
Loss of suction
MAINTENANCE & CLEANING

TROUBLESHOOTING

Cause...
Loose Power Cord
Blockage
Dust Container is too full
Missing/damaged filter
Solution...
Remove plug from mains and
re-insert
Check openings for any
obstructions and remove
Remove and empty the Dust
Container ( see page 5 )
Replace the filter ( see page 5 )
| 5 |