Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
Page 4
警示: To disconnect a network cable, first unplug the cable from your computer and then unplug the cable from the network device. Disconnect all network cables from the computer. Disconnect your computer and all attached devices from their electrical outlets. Close the display and turn the computer upside-down on a flat work surface.
After you complete any replacement procedure, ensure you connect any external devices, cards, and cables before turning on your computer. 警示: To avoid damage to the computer, use only the battery designed for this particular Dell computer. Do not use batteries designed for other Dell computers.
Front and Back View network connector USB 3.0 connector HDMI connector microphones (optional) camera camera-status light power connector microphone power button Mini-DisplayPort connector USB 3.0 connector with PowerShare memory-card reader contactless smart-card reader (optional) fingerprint reader (optional)
註: You may need a sharp tool to pry the base cover from its edge. Installing the Base Cover Place the base cover to align with the screw holders on the computer. Tighten the screws to secure the base cover to the computer. Follow the procedures in After Working Inside Your Computer.
a. Remove the screw that secures the battery to the computer [1]. b. Lift and push to remove the battery from the computer [2] [3]. Installing the Battery Insert the battery into its place on the computer. Route the battery cable through its routing channel. Tighten the screw to secure the battery to the computer.
Page 11
Remove the hard-drive assembly from the computer. Pull to release the hard-drive cable from its connector.
Remove the screws that secure the hard-drive bracket to the hard drive [1] and remove the hard drive from the hard-drive bracket [2]. Installing the Hard-Drive Assembly Place the hard-drive bracket on the hard drive to align the screw holders and tighten the screws to secure the hard-drive bracket.
battery base cover Follow the procedures in After Working Inside Your Computer. Removing the Memory Follow the procedures in Before Working Inside Your Computer. Remove the: base cover battery Pry the clips securing the memory module until the memory pops-up and remove the memory from the system board.
Page 14
註: You may need a sharp tool to pry the keyboard trim from its edges. Remove the keyboard trim from the keyboard. 安裝鍵盤邊條 將鍵盤邊條插入鍵盤直到它卡在固定位置。 按照拆裝電腦內部元件之後中的程序進行操作。 卸下鍵盤 按照拆裝電腦內部元件之前中的程序進行操作。 卸下: 基座護蓋 電池 鍵盤邊條 將鍵盤纜線從主機板的連接器拔下。 卸下將鍵盤固定在電腦上的螺絲。...
Page 44
系統設定選項 註: 視電腦和安裝的裝置而定,此部分列出的項目不一定會出現。 表 1. General (一般) 選項 說明 System 此部分列出您電腦的主要硬體功能。 Information • System Information (系統資訊):顯示 BIOS Version (BIOS 版本)、Service Tag (服務 標籤)、Asset Tag (資產標籤)、Ownership Date (擁有權日期)、Manufacture Date (製 造日期),以及 Express Service Code (快速服務代碼)。 • 記憶體資訊:顯示已安裝的記憶體、 可用記憶體、 記憶體速度、 記憶體通道模式、 記憶體技術、DIMM A 大小和 DIMM B 大小。 Processor Information (處理器資訊):顯示...
Page 45
選項 說明 • Disabled (已停用) Enabled (已啟用) • Enabled w/PXE (已啟用 w/PXE):此選項預設為啟用。 • Parallel Port 可讓您設定擴充基座上的並列埠。選項包括: Disabled (已停用) • • AT:此選項預設為啟用。 • • Serial Port 可讓您設定內建序列埠。選項包括: Disabled (已停用) • • COM1:此選項預設為啟用。 COM2 • COM3 • • COM4 SATA Operation 可讓您設定內部 SATA 硬碟機控制器。選項包括: Disabled (已停用) •...
Page 46
選項 說明 USB PowerShare 此欄位配置 USB Powershare 功能的行為。此選項允許您透過 USB PowerShare 連接埠使用存儲系統電池的電源為外接設備充電。 Audio 此欄位可啟用或停用整合式音效控制器。在預設下,Enable Audio (啟用音 效) 選項已選取。 Keyboard Illumination 此欄位允許您選擇鍵盤照明功能的作業模式。 鍵盤亮度級別可設定為 0% 至 100% • Disabled (已停用) • 暗淡 • 明亮 此選項預設為已停用。 Keyboard Backlight with AC 鍵盤以交流電選項為背光源,並不影響主鍵盤照明功能。鍵盤照明將繼續支 援各種照明水準。當背光功能開啟時此欄位有效。 Unobtrusive Mode 此選項在啟用時,按下...