Replacing Lamps - Sunquest PRO 24RS Assembly And User's Manual

Replacing Lamps

Introduction
To be assured of maximum tanning effec-
tiveness, change lamps after approxi-
mately 800-1000 hours of use. Tanning
will continue after this time but at a slow-
er rate. To ensure trouble-free operation
of your sunbed, replace the lamp starters
whenever the lamps are replaced.
Warning! Disconnect sunbed from elec-
trical power before servicing.
Removing/Replacing Acrylic Shields
The acrylic shields in the canopy and
bench are both secured in place by col-
ored profile strips which run the length of
the canopy and bench, both front and
back. To remove the strips, gently pry up
on the outside edge of the strip near the
middle of the bed with a flat, blunt object
(such as a putty knife) until the retainer
releases its latching action (See figure
below). Continue prying up the strip
throughout its full length until removed.
Repeat for the other strips. The long
edges of the acrylic shield are now
exposed.
Care & Maintenance-Replacing Lamps
Canopy Shield
Standing in front of the sunbed, grasp the
long exposed edge of the acrylic and
carefully begin sliding it toward you, until
it is removed from the sunbed. You may
need to pull the shield edge down slight-
ly to clear the edge of the bed.
Bench Shield
Slide the acrylic shield toward the head
or foot end of the bed. The short edge of
the acrylic shield at the opposite end
should now be visible. Remove the shield
by lifting from this end.
After changing lamps, replace the acrylic
shield by reversing the above steps. On
bench shields, take special care to
ensure that the acrylic is centered from
head to foot before installing the
retaining strips. Replace each retainer
by first installing its ends into place under
the endcaps, then working toward the
center, pushing it into place.
Profile Strip
Acrylic Shield
Putty Knife
13