Printer Driver Problems; Section 12.4 Printer Driver Problems - Magicard Rio Pro Maintenance Manual

SECTION 12.4

PRINTER DRIVER PROBLEMS

Problem
When a document is sent nothing
happens at the Printer.
When a document is sent to the
Printer it appears in the print queue
(Spooler) but nothing happens at
the Printer.
Print document is jammed in the
print queue (Spooler).
When a document is sent to the
Printer it appears in the print queue
(Spooler) and disappears
immediately.
Unable to open the Printer settings
within "Printers and Faxes".
After installing the Driver and
connecting the Rio Pro nothing
happens, Printer is not seen.
After installing the Driver and
connecting, Windows registers the
Printer but nothing appears in the
Printer list.
After installing the Driver and
connecting the Printer "Found New
Hardware" Wizard appears.
Ultra Electronics Card Systems
Probable Causes
Printer is "Offline".
1.
2. Incorrect Printer selected within the
Operating System.
3. Incorrect Port selected in the Driver
settings.
4. Corrupted or deleted Driver within the
Operating System.
Printer is "Off-Line".
1.
Windows Spooler is "Paused".
2.
1. Corrupted Print Job sent to Printer.
Printer is "Off-Line".
2.
3. Incorrect Port selected in the Driver
settings.
1. Incorrect Port selected in the Driver
settings.
2. Corrupted Printer Driver.
1. Corrupted Printer Driver.
Printer is "Off-Line".
1.
2. Problem with the USB Port.
3. Problem with the USB cable.
4. Corrupted Printer Driver.
5. Damaged Controller PCB.
Printer is "Off-Line".
1.
2. Corrupted Printer Driver.
3. Conflicting Printer Driver files.
4. Damaged Controller PCB.
"Beta" Driver is/has been installed.
1.
2. Partitioned Hard Drive.
Rio Pro Maintenance Manual
Possible Solutions
1. Re-initialise the Printer ensuring
Dye-Film is fitted and it reports
"Ready".
2. Ensure the printing application is
set to print to the Rio Pro. Perhaps
it should be set as the default
Printer.
3. USB printing Port should be
selected to USB001.
4. Remove the current Driver and re-
install the latest version.
1. Re-initialise the Printer ensuring
Dye-Film is fitted and it reports
"Ready".
2. Right Click on the Printer Driver
and choose "Unpause Printer".
1. Delete the Print Job from the queue
and resend the document.
2. Re-initialise the Printer ensuring
Dye-Film is fitted and it reports
"Ready".
3. USB printing Port should be
selected to USB001.
1. USB printing Port should be
selected to USB001.
2. Remove the current Driver and re-
install the latest version.
1. Remove the current Driver and re-
install the latest version.
1. Re-initialise the Printer ensuring
Dye-Film is fitted and it reports
"Ready".
2. Try connecting to another spare
USB Port.
3. Try a known working USB cable.
4. Contact Magicard Technical
Support for another Controller PCB.
1. Re-initialise the Printer ensuring
Dye-Film is fitted and it reports
"Ready".
2. Remove the current Driver and re-
install the latest version.
3. Remove all other Card Printer
Drivers.
4. Contact Magicard Technical
Support for another Controller PCB.
1. Contact Magicard Technical
Support for advice about removing
"Beta" Drivers.
2. Install the Driver onto the partition
where the Operating System is
loaded. You may have to copy files
from one partition to another.
- 59 -
Reference Section