GE NX-4-EUR Installation Manual page 73

LOCATIONS 207-211 - RESERVED
LOCATION 212 – PROGRAMMING THE LCD KEYPAD ADDRESS (1 segment, numerical data)
When using the XSIA dialler format, the system requires at least 1 LCD keypad. The panel will
get the zone descriptions from the first language from that LCD keypad which has the address
defined in location 212. If your system has an LCD keypad it is recommended that it will be
placed in location 1 keypad 1. This will allow location 212 to be left at the factory default. If the
LCD keypad is selected as something other than partition 1 / keypad 1, program the
appropriate address in location 212. Select the address from the location chart.
Keypad
LOCATION 213 – PROGRAMMING THE COUNTRY CODE (1 segment, numerical data)
The NX-4 has the ability to set different "country codes". Each country code has specific
default settings. Before start programming the NX-4, it is important to select the country code
that is required (see table below). Once the country code has been selected, it will remain set,
even after an installer reset. When changing the country code during programming, all
existing programming will be cleared to the defaults for that country (see location 213).
Code
NX-4-EUR Installation manual
Part 1
1 192
2 200
3 208
4 216
5 224
6 232
7 240
8 248
Country
0 No country (default)
1 Holland
2 Belgium / Poland
3 Sweden
4
5
6 Greece
7 South Africa
8
9 Reserved
10 Turkey
50
Page 73
Italy
Spain
Israel
US
02/07/06