Advertisement
www.elsonhotwater.co.uk
providing mains pressure hot water
Installation, Servicing
and User's Instructions
Read these instructions thoroughly before installing the unit.
COMPLIES WITH PART L BUILDING REGULATIONS
Elson is a member of the Benchmark initiative and
fully supports the aims of the programme.
Benchmark has been introduced to improve the
standards of installation and commissioning of
central heating systems in the UK and to
encourage the regular servicing of all central
heating systems to ensure safety and efficiency.
Elson Coral E
Open Vented Thermal Store
heated by electricity
Leave these instructions with the User.
Service Helpline 08450 770087
Part No. 130009 Iss. 12
August 2004
For Technical Help or Sales
queries contact 0191 4270777
Advertisement
Table of Contents
Related Manuals for Elson coral e
Summary of Contents for Elson coral e
- Page 1 COMPLIES WITH PART L BUILDING REGULATIONS For Technical Help or Sales queries contact 0191 4270777 Elson is a member of the Benchmark initiative and fully supports the aims of the programme. Benchmark has been introduced to improve the standards of installation and commissioning of...
-
Page 2: Table Of Contents
(a special Coral E and the frame). Note a minimum clearance of 225 mm must be allowed above the units. A version of the 150 litre model is available as a packaged unit (Coral E 150 EBF) to accommodate an electric boiler (not supplied). A frame is supplied complete with fixing brackets for the boiler. -
Page 3: Important Notes
85°C, with a mains cold water supply temperature of 10°C and the following constant draw off rates:- Coral E 210 - 18 litres/min. Coral E 150 - 18 litres/min. Coral E 100 - 12 litres/min. 260 280 300... -
Page 4: Installation
(RH side only) Drain boss Fig. 1 - Coral E 100 UWS Fig. 2 4. INSTALLATION 4.1. Position the unit and make the water connections Refer to Fig. 2 for the recommended route of the pipework to the unit. -
Page 5: Commissioning
Adjust the valve as shown in Fig 3 (using the adjusting key supplied) until the desired mixed outlet temperature is achieved. Repeat paragraphs 1 - 4. Replace the valve cap and close the outlet. A record of the commissioning settings should be made for comparison with future maintenance checks. Coral E... -
Page 6: Servicing/Replacement Of Parts
Complete the installation details on the back page of this booklet. 6. SERVICING If the unit is installed in a hard water area and is suffering from scaling problems, contact the Elson Technical Helpline on 0191 4270777 for information on descaling. -
Page 7: Spare Parts List
85°C). The bottom thermostat may have been reduced slightly (not below 75°C) where it is known that hot water demand will not be high. Replace the covers. 7. SPARE PARTS LIST The following specialist spare parts for the Coral E are readily available from Elsy & Gibbons Limited:- Item Part No. Limit thermostat ........... 10010002 Control thermostat .......... -
Page 8: User's Instructions
For the most economical use of the Coral E you should restrict your main use of hot water (baths etc.) to such a time that the water in the unit will be re-heated during the off-peak period.
Need help?
Do you have a question about the coral e and is the answer not in the manual?
Questions and answers