Additional Safety Rules - ABB Superfix 220 Instruction Manual

Additional Safety Rules

Assembly
10
Read the Safety Instructions booklet and the following before using.
1) Be aware that this tool is always in an operating condition, since it does
not have to be plugged into an electrical outlet.
2) When drilling or driving into walls, floors, etc., "live" electrical wires may
be encountered. DO NOT TOUCH THE CHUCK OR ANY FRONT METAL
PARTS OF THE TOOL! Hold the tool only by the plastic handle to prevent
electric shock in case you drill or drive into a "live" wire.
3) If the bit becomes jammed, immediately turn the main switch off to pre-
vent an overload, which can damage the battery pack or motor. Use rever-
se motion to loosen jammed bits.
4) Do NOT operate the reversing lever when the main switch is on. The bat-
tery will discharge rapidly and damage to the unit may occur.
5) During charging, the charger may become slightly warm. This is normal.
Do NOT charge the battery for a long period.
6) Use only a dry, soft cloth to wipe the unit. Do NOT use a damp cloth, thin-
ner, benzine or other volatile solvents for dearing.
7) When storing or carrying the tool, set the reversing lever to the center po-
sition (switch lock).
8) Do not strain the tool by holding the speed control trigger halfway (speed
control mode) so that the motor stops.
9) Do not operate the speed selector switch (LOW-HIGH) while pulling on
the speed control trigger. This can cause the rechargeable battery to we-
ar quickly or damage the internal mechanism of the motor.
10) The appliance is not intended for use by young children or infirm persons
without supervision.
11) Young children should be supervised to ensure that they do not play with
the appliance.
Attaching or removing bit
Note:
When attaching or removing a bit, be sure to set the reversing lever to its cen-
ter position (switch lock).
This tool is equipped with a keyless drill chuck.
1) Attachment
Insert the bit and turn the lock collar clockwise (looking from the front) to
tighten. (Fig. 2)
2) Removal
Turn the lock collar counterclockwise (looking from the front), then remo-
ve the bit. (Fig. 3)
3) Storage
Keep the bit in bit holder when not in use. Remove the battery pack to ex-
pose the bit storage compartment inside the handle housing.
Bits up to 50 mm (1-31/32 inch) long can be stored here. (Fig. 4)
Note:
If excessive play occurs in the chuck, ➀ secure the drill in place and tighten
the chuck by turning k clockwise, ➁ open the chuck claws by unscrewing the
A
lock collar and ➂ tighten the screw (left-handed screw) with a screwdriver by
turning it counterclockwise (viewed from the front). (Fig. 5)
Attaching or removing battery pack
1. To connect the battery pack:
Insert the battery pack. lt snaps into place to indicate proper connection.
2. To remove the battery pack:
Press the two tabs or the sides of the battery pack. Slide the battery pack
out of the tool body.