Configuring The Electronic Boards; Software Update - Necta Astro Installation, Operating And Maintenance Manual

Fig. 29
1 - J14 Coin mechanism power supply
2 - J15 Board power supply
3 - Green LED: run (DL2)
4 - Yellow LED: 5 V DC (DL1)
5 - 24 V output connection
6 - 24 V output connection
7 - Red LED: CPU board reset (DL3)
8 - J3 Input/output
9 - J4 not used
10 - J5 programmer (RS232)
11 - J6 not used
12 - J7 can bus
13 - Button not used
14 - J8 Validators
15 - J9 not used
16 - J10 LCD (Liquid crystal display)
17 - J11 Push-button panel
18 - J16 Push-button panel
19 - J12 MDB coin mechanism
20 - Coin mechanism setting Minidip (SW2)
21 - J13 Expansion for BDV/EXE
© by NECTA VENDING SOLUTIONS SpA

CONFIGURING THE ELECTRONIC BOARDS

The electronic boards are designed to be used in many
machine models.
When the boards are replaced, or when wishing to change
the unit performance, ensure that the board configuration is
correct and download the appropriate software.

SOFTWARE UPDATE

The machine is fitted with Flash EPROMs which can be
electronically updated.
By means of a special program and suitable system
(Personal Computer or similar) the machine management
software can be updated without replacing the EPROMs.
28
0210 206-00