Sanyo DC-C30 Instruction Manual page 3

Hide thumbs Also See for DC-C30:
Table of Contents

Advertisement

CONNECTIONS
—.'..
—..—.
. .
'M outdoor aerial
AM loop aerial
FM indoor aerial
P
I
/
-L
Video equipment/DVD
player
1/
0-
R ch
L ch
speaker
speaker
—— ——
——
——
——
.—
— ———
———
.
Note:
Do not connect
the mains lead to an AC outlet until all
connections
have been made.
The system is not completely
disconnected
from the mains
when the &/ON button is set to the C5position.
When the unit is first connected, the display switches automatically
to the demonstration
mode. To cancel this mode, turn the power
on or press the DISPLAY button.
Speakers
When connecting
the speakers,
make sure that (+) and (-)
polarities
are matched
properly.
Otherwise,
the sound may
appear to be lacking in the bass range and in stability.
Connect the speaker wire with the stripe to the red terminal (+)
and the other wire to the black terminal (–).
.——
— ———
———
———
———
FM aerial
The FM indoor aerial is sufficient to receive most local FM broadcasts and
should be connected to the FM 75 Q terminal. Extend the aerial wire as
straight as possible and, while listening to the sound from the system,
secure it in a position which yields minimal distortion and noise.
In fringe areas or where reception is distorted or noisy, an FM outdoor
aerial (not supplied) should be connected instead of the indoor aerial. The
terminals will accept 75-ohm coaxial cable. Consult your dealer.
AM loop aerial
Assemble the loop aerial as shown in figure. Unwind the aerial wires, then
connect them to the AM LOOP terminals. Place the loop aerial in a position
which yields the best AM reception, or attach it to a wall or other surface
as shown in figure.
~o
To an AC outlet
Note:
To minimize noise, the speaker, mains and any other leads should not
come close to the FM indoor or outdoor aerial lead and AM loop aerial. Do
not place the aerial leads close to the system.
Video equipment/DVD
player
Connect audio leads (not supplied) from the audio output sockets of a
video equipment/DVD
player to the VIDEO/DVD
IN sockets.
Headphones
Connect stereo headphones
(not supplied)
to the PHONES socket for
monitoring
or for private
listening.
The speakers
are automatically
disconnected
when headphones
are connected.
-2-

Advertisement

Table of Contents
loading

Table of Contents