Table of Contents
Advertisement
AR-FX2
[3] INSTALLING PROCEDURE
1. FAX expansion kit, LCD panel kit instal-
lation
G When installing the FAX expansion kit, the LCD panel kit is required.
Parts included in the FAX expansion kit
(2) FAX PWB
(1) FAX key unit
(5) FFC harness
(6) FAX harness
(9) M3 screws (gold color)
(10) Harness securing tape (11) Supplied label
(12) Label for note
(13) FCC Registration Label
(15) Operation manual
Packed items of the LCD panel kit
LCD unit
Installation fixture
Motherboard
Ground plate
M3 screws(gold color)
Note: Before performing this procedure, be sure to disconnect the
power plug from power outlet. If not, an electric shock may be
resulted.
1) Remove the front cover of the copier machine.
G Open the bypass tray and the side cover. Remove the paper tray.
Warp the front cover inside by pressing the both sides, and remove
the front cover from the hinge arm of the machine.
(3) TEL/LIU PWB
(4) Speaker unit
(7) Line harness (8) M3 screws (gold color)
(14) FAX connector cover
(16) Installation manual
M3 screws(silver color)
2) Remove the operation panel.
G Remove the operation panel fixing screw, and remove the flat cable.
3) Remove the ground wire. (Note: Depending on model or version,
select the appropriate diagram (A or B) for ground wire removal.)
(A) Remove the screw, and remove the ground wire. Then install the
screw on the left side.
(B) Remove the screw, and remove the ground wire.
4) Remove the cover.
G Remove the screw, and attach the LCD dummy cover and the FAX
dummy cover.
5) Install the LCD unit.
G Attach the LCD unit from your side, engage the pawls with the at-
tachment holes, and fix with screws. Then connect the flat connec-
tor.
(1)
M3X8
3 – 1
(1)
(2)
Blue line-must be up
(2)
(3)
Advertisement
Table of Contents
