Maintaining Your Ice Maker; Cleaning The Interior Of Your Ice Maker - Insignia NS-IMP26BK7 User Manual

4 Press the SELECT button to choose the size of ice produced.
The ice making cycle takes from 6 to 13 minutes to complete,
depending on the ice cube size selected and the room temperature.
The ice maker stops when the ice basket is full (the ICE FULL indicator
turns on).
5 Discard the first few batches of ice the first time you use the ice maker,
or the first time you use it after an extended period of time.

Maintaining your ice maker

Your ice maker is designed for year-round use with only minimal cleaning
and maintenance.
When you first receive it, wipe the outside with a mild detergent and
warm water, then wipe dry with a dry cloth. Do this periodically to keep
your ice maker looking new.

Cleaning the interior of your ice maker

1 Unplug the ice maker.
2 Take out the ice basket.
3 Clean the interior with diluted detergent, warm water, and a soft cloth.
4 Use clean water to rinse the inside parts, then drain the water by
unplugging the drain cap on the front bottom side.
5 Dry the interior with a clean soft cloth.
6 When the machine is not to be used for a long time, drain the water
completely and dry the interior.
8
Notes
• If the room temperature is below 60° F (15.6° C), select the
SMALL ice cube size to prevent the ice cubes from sticking
together.
• Press and hold the SELECT button for five seconds to run 10
continuous cycles, even when the ICE FULL indicator is on.
Caution
• Direct sunlight or reflected sunlight may cause the infrared
sensor to malfunction. If the unit does not stop making ice
cubes even when full, move the ice maker to a darker
location.
• You must change the water in the tank at least every 24
hours to ensure a reasonable hygene level and avoid bad
smelling ice.
Caution
To prevent damage to the finish, do not use:
• Gasoline, benzine, thinner, or other similar solvents.
• Abrasive cleaners.
www.insigniaproducts.com
NS-IMP26BK7/NS-IMP26SS7