Advertisement
QUICK SETUP GUIDE
Portable
Ice Maker
NS-IMP26SL0
Before using your new product, please read these instructions to prevent any damage.
PACKAGE CONTENTS
• Portable ice maker
• Ice basket (pre-installed)
• Ice shovel
• Quick Setup Guide
IMPORTANT SAFETY INFORMATION
• Read these instructions.
• Keep these instructions.
• Heed all warnings.
• Follow all instructions.
• Do not operate your ice maker with a damaged cord.
• Your ice maker requires a standard 110-120volt, 60Hz electrical outlet with a
three-prong ground.
• Connect to a properly polarized outlet only. No other appliance should be plugged
into the same outlet. Make sure that the plug is fully inserted into the outlet.
• Do not run the power cord over carpeting or other heat insulators. Do not cover the
cord. Keep the cord away from traffic areas, and do not submerge in water.
• We do not recommend the use of an extension cord because it may overheat and
become a risk of fire. If you must use an extension cord, use No.14 AWG minimum
size and rated no less than 1875 watts.
• Unplug your ice maker before cleaning or making any repairs or servicing.
• Exercise caution and use reasonable supervision when your ice maker is used near
children.
• Do not use your ice maker outdoors.
• Place your ice-maker away from direct sunlight and make sure that there is at least
4 inches (10 cm) of space between the back and sides of your ice maker and
surrounding walls.
• Do not use any other liquid besides water to make ice cubes.
• Do not clean your ice maker with flammable fluids. The fumes can create a fire hazard
or explosion.
• Do not tip over.
• If your ice maker is brought in from outside storage in winter, wait a few hours for it
to warm up to room temperature before plugging it in.
• To avoid a hazard due to instability of your ice maker, it must be placed on an even or
flat surface.
WARNING: This appliance must be grounded.
FEATURES
• Produces up to 26 lbs. (11.8 kg) of ice each day
• Stores up to 1.5 lbs. (.68 kg) of ice
• Quick production cycle creates ice every 6 to 13 minutes
• Auto-detect prevents ice from overflowing when the basket is full
• Two ice cube sizes help create the perfect drink
• Removable ice basket gives you convenient access
• Water recycling system with reservoir lets you place your ice maker
anywhere
OVERVIEW
Control panel
ICE FULL indicator
Ice cube size
Lights when the ice
Lights to indicate the
basket is full.
selected ice cube size.
SELECT button
Press to select the
ADD WATER indicator
ice cube size:
Lights when you need
SMALL or LARGE
to add water.
POWER indicator
Lights when your ice
maker is turned on.
ON/OFF button
Press to turn your ice
maker on or off.
Ice maker
Cover
Lift to remove ice.
Ice scoop
Moves ice into the ice basket.
Ice full sensor
Senses when the ice maker is full.
Ice basket
Holds ice.
Ventilation opening
Provides cooling. Do not block.
Water drain plug
Unplug to drain water.
Ice shovel
Use to remove ice from the basket.
UNPACKING YOUR ICE MAKER
Remove the exterior and interior packaging. Make sure that you unpack the
ice basket and ice shovel. If any parts are missing, contact Best Buy customer
service.
Note: Make sure that your ice maker is positioned so that the plug is accessible.
Advertisement
Table of Contents
Related Manuals for Insignia NS-IMP26SL0
Summary of Contents for Insignia NS-IMP26SL0
- Page 1 POWER indicator three-prong ground. Lights when your ice NS-IMP26SL0 • Connect to a properly polarized outlet only. No other appliance should be plugged maker is turned on. into the same outlet. Make sure that the plug is fully inserted into the outlet.
- Page 2 5 Press the ON/OFF button. The power indicator lights. qualified service technician for repair. INSIGNIA is a trademark of Best Buy and its affiliated companies 6 Press the SELECT button to select the ice cube size. If the room temperature is Distributed by Best Buy Purchasing, LLC lower than 60°F (16°C), we recommend that you select the small cube size to...
Need help?
Do you have a question about the NS-IMP26SL0 and is the answer not in the manual?
Questions and answers
cannot get the part where the ice freezes on the metal bars clean. the white part around that, when it moves, is black and red on back. I cannot get to it to clean it... please help!! thanks
To clean the ice freezing area on the Insignia NS-IMP26SL0, follow these steps:
1. Ensure the machine is unplugged for safety.
2. Clean the interior with a diluted detergent, warm water, and a soft cloth.
3. Rinse thoroughly with clear water to remove any detergent residue.
4. Clean the ice bucket and scooper as well.
5. Before first use, run two to three cycles of ice and dispose of them to remove any plastic odor or residue.
This process helps maintain cleanliness and ensures better ice quality.
This answer is automatically generated
thanks for your answer, but I have done all that and the black and red residue still shows on the back of the part that dumps the ice into the bottom of the unit. I can find no way way to access the back of that part. any ideas? thanks so much
Does the power light flash on and off when the power is off
Yes, the power light on the Insignia NS-IMP26SL0 flashes when the unit is off, indicating it is in standby mode.
This answer is automatically generated